ESDU AERO C.04.01.02
Rate of change of hingemoment coefficient with control deflection for a plain control in incompressible twodimensional flow, (b_{2})_{0}
Abstract:
ESDU Aero C.04.01.02 derives the slope of the hinge moment coefficient curve against control deflection for a special series of aerofoils having straight upper and lower surfaces over the rear 10 per cent of chord with a trailingedge half angle with tangent equal to the aerofoil thickness/chord ratio. The results have then to be corrected for the effect of trailingedge angle. For the special series a graph plots curves of the theoretical rate of change of hinge moment coefficient with control deflection for inviscid flow against control chord to aerofoil chord ratio for various values of thickness/chord ratio. A second graph gives curves that allow the theoretical value to be corrected for the effects of viscosity since they give the ratio of the slope of the hinge moment coefficient curve with control deflection in incompressible flow to that theoretical value. The curves are plotted against control chord to aerofoil chord ratio. Each curve applies to a value of the ratio of the rate of change of lift coefficient with control deflection in incompressible flow to that in inviscid flow and that ratio may be obtained from ESDU Aero C.01.01.03. The hinge moment coefficient curve slope is finally corrected for the effect of trailingedge angle if it is not as defined for the special series of aerofoils using an equation that involves the slopes of the lift coefficient curves with control deflection in viscous and inviscid flow, the thickness/chord ratio, and the trailingedge angle defined by lines joining points on the aerofoil surface at 95 and 99 per cent of chord. The method applies for sealed gaps or gaps not exceeding 0.002 times chord and when the hinge moment coefficient curve with incidence is linear. It is accurate to 0.05/radian. ESDU 89009 may be used to correct for finite aspect ratio effects.Indexed under:
Details:
Data Item ESDU AERO C.04.01.02  

Format: 

Status: 

Previous Releases: 

ISBN: 

The Data Item document you have requested is available only to subscribers or purchasers.
 Subscribers login here.
 If you are not an ESDU subscriber you can
 find out how to subscribe, or
 purchase this Data Item from the IHS Standards Store.
The graphs listed below are available only to subscribers.
 Subscribers login here.
 If you are not an ESDU subscriber find out how to subscribe.
This Data Item contains 2 interactive graph(s) as listed below.
Graph  Title 

Figure 1  
Figure 2 
Explore ESDU
ESDU Series:
 Aerodynamics
 Aircraft Noise
 Composites
 Dynamics
 Fatigue  Endurance Data
 Fatigue  Fracture Mechanics
 Fluid Mechanics, Internal Flow
 Fluid Mechanics, Internal Flow (Aerospace)
 Heat Transfer
 Mechanisms
 Performance
 Physical Data, Chemical Engineering
 Stress and Strength
 Structures
 Transonic Aerodynamics
 Tribology
 Vibration and Acoustic Fatigue
 Wind Engineering
ESDU Packages:
Copyright © 2020 IHS Markit. All Rights Reserved